Good News!The Flydumps Cisco 642-973 exam questions and answers covers all the knowledge points of the real exam. With our Cisco 642-973 practice test, you will never worry about the exam.Recently the new version with all new updated Cisco 642-973 exam dumps can free download on the site Flydumps.com.Visit the site to get more exam information.
Exam A
QUESTION 1
Which command is used to enable Cisco NSF for BGP?
A. 6500(config-router)# bgp graceful-restart
B. 6500(config-router)# bgp nsf
C. 6500(config)# bgp enable nsf
D. 6500(config-router)# enable nsf-capable
E. 6500(config-router)# nsf
Correct Answer: A Section: (none) Explanation
Explanation/Reference:
QUESTION 2
You are using RPR. A switchover event will be triggered if either of which two of these fails? (Choose two.)
A. An administratively monitored line card
B. A service module
C. A DFC on a monitored line card
D. An inter-supervisor clock synchronization
E. An active supervisor MSFC
Correct Answer: DE Section: (none) Explanation
Explanation/Reference:
QUESTION 3
Which three of these are examples of FHRPs? (Choose three.)
A. HSRP
B. Proxy ARP
C. IRDP
D. VRRP
E. GLBP
F. RIP
Correct Answer: ADE Section: (none) Explanation
Explanation/Reference:
2 http://www.hotcerts.com 642-973
QUESTION 4
A customer has installed an FWSM in the data center. Which feature must be configured to enable FTP to work?
A. Dynamic NAT
B. Dynamic PAT
C. Access lists
D. Transparent mode
E. Deep packet inspection
Correct Answer: E Section: (none) Explanation
Explanation/Reference:
QUESTION 5
Which ingress QoS trust setting sets the CoS or ToS values of any frame entering that port to zero?
A. Trust CoS
B. Trust IP precedence
C. Untrusted
D. Trust DSCP
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 6
In a Cisco Catalyst 6500 Series Switch, which engine is required in order to use the distributed Cisco Express Forwarding architecture?
A. DFC
B. PFC3A
C. MSFC3
D. PFC3B
E. PFC3BXL
Correct Answer: A Section: (none) Explanation
Explanation/Reference:
3 http://www.hotcerts.com 642-973
QUESTION 7
Which two features make up the fault management framework? (Choose two.)
A. CiscoWorks application
B. Generic Online Diagnostics
C. Soft high availability
D. HP OpenView
E. CiscoWork Resource Management Essentials
Correct Answer: BC Section: (none) Explanation
Explanation/Reference: QUESTION 8
Which command is used to enable Cisco NSF for EIGRP?
A. 6500(config-router)# eigrp nsf
B. 6500(config)# eigrp enable nsf
C. 6500(config-router)# enable nsf-capable
D. 6500(config-router)# nsf
Correct Answer: D Section: (none) Explanation
Explanation/Reference:
QUESTION 9
Which NAM data-collection method will provide a summary report of utilization and error rates on each switch interface?
A. SPAN
B. VACLs
C. Mini-RMON
D. Core monitoring
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 10
Which command can be used to regain access to a non-responding Cisco NAM in slot 3?
4 http://www.hotcerts.com 642-973
A. Module slot 3 reset
B. Reload module slot 3
C. Slot 3 reload
D. Hw-module module 3 reset
Correct Answer: D Section: (none) Explanation
Explanation/Reference:
QUESTION 11
What must be configured on the FWSM to forward traffic to a filtering server?
A. The filtering server as an authentication provider (aaa-server)
B. All web traffic so that it is directed only to the filtering server (access-list)
C. All HTTP requests so that they are redirected to the filtering server (fixup protocol)
D. All HTTP requests so that they are sent to the filtering server (url-server) Correct Answer: D
Section: (none) Explanation
Explanation/Reference:
QUESTION 12
HSRP active and standby routers send hello messages to which multicast address?
A. IP address 224.0.0.18, IP protocol number 112
B. IP address 224.0.0.2, UDP port number 2000
C. IP address 224.0.0.2, UDP port number 1985
D. IP address 224.0.0.102, UDP port number 3222
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 13
What must be configured on the NAM to allow an NMS to access the NAM?
A. VACLs
B. HTTPS service
C. SNMP community strings
D. TACACS+ authentication 5 http://www.hotcerts.com 642-973
Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 14
What must you do to enable HTTPS as the access protocol on the NAM?
A. Enable the HTTP server, then enable the SSL service.
B. Install a strong crypto patch on the NAM, then enable the HTTPS server.
C. Ensure that 128-bit cryptography is enabled, then enable the HTTPS server.
D. Enable the HTTP server, then issue the http secure server enable command.
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
If you plan to use the HTTP secure server (HTTPs), then you must first download and install the NAM software K9 crypto patch. Until you install the patch, the ip http secure commands are disabled. You can download the NAM software K9 crypto patch from Cisco.com.
Reference: http://www.cisco.com/en/US/docs/ios/12_3/12_3x/12_3xd/feature/guide/nm_nam.html
QUESTION 15
Which of these actions must be taken in order to support an EEM script on a system that is enabled for Cisco Catalyst 6500 VSS 1440?
A. The EEM script must be uploaded via CiscoWorks.
B. The EEM script must be loaded to both supervisor modules.
C. The EEM script must be uploaded on the active supervisor module only.
D. VSS must be disabled, the EEM script uploaded, and VSS re-enabled.
Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 16
Which two functions are performed by the Link Management Protocol? (Choose two.)
A. Determine which ports comprise the VSL
B. Track and reject unidirectional links
C. Determine the compatible hardware version
D. Exchange the chassis ID between the two switches
E. Determine the active and standby control plane roles
Correct Answer: BD Section: (none) Explanation
Explanation/Reference:
6 http://www.hotcerts.com 642-973
QUESTION 17
Which two tools are used to define EEM policy? (Choose two.)
A. CLI applet
B. Tcl script
C. CiscoWorks Agent
D. SNMP Trap
E. Protocol Definition Language Module
Correct Answer: AB Section: (none) Explanation
Explanation/Reference:
QUESTION 18
Which of these commands sets GigabitEthernet3/3 and GigabitEthernet 3/12 as sources of a local SPAN session?
A. Monitor session 1 source interface GigabitEthernet3/3, 12
B. Monitor session 4 source interface GigabitEthernet3/3, GigabitEthernet3/12
C. Monitor session 1 source list GigabitEthernet3/3, 3/12
D. Monitor session 3 source interface list GigabitEthernet3/3, 3/12
Correct Answer: B Section: (none) Explanation Explanation/Reference:
QUESTION 19
Which of these is a requirement for RPR+ deployment?
A. The supervisor Ethernet ports must be connected for synchronization
B. The startup configuration must be manually synchronized
C. The installed line cards must be Cisco Catalyst 6700 Series line cards
D. Two identical supervisors must be used
Correct Answer: D Section: (none) Explanation
Explanation/Reference:
QUESTION 20
7 http://www.hotcerts.com 642-973
The Cisco NAM in slot 7 does not have an initial configuration yet. Which of these commands can be used to access this Cisco NAM?
A. Session slot 7 processor 1
B. Hw-module module 7 console
C. Slot 7 session console
D. Session slot 7 console
Correct Answer: A Section: (none) Explanation
Explanation/Reference:
Both PDF and software format demos for Cisco 642-973 exam dumps are offered by Flydumps for free.You can try Cisco 642-973 free demo before you decide to buy the full version practice test.Cisco 642-973 exam dumps details are researched and produced by our Professional Certification Experts who are constantly using industry experience to produce precise, and logical.Cisco 642-973 exam dumps will not only help you pass in one attempt,but also save your valuable time.
