Cisco 350-001 Questions And Answers, New Release Cisco 350-001 Answers With New Discount

100% valid Cisco 350-001 brain dumps with more new added questions.By training the Cisco 350-001 questions, you will save a lot time in preparing the exam.Visit www.Flydumps.com to get the 100% pass ensure!

QUESTION 11
Load sharing of VLAN traffic over parallel ISL trunks is:
A. Not possible due to the nature of ISL.
B. Configurable on a per VLAN basis.
C. Configurable on a per packet basis.
D. Automatic due to the nature of ISL and its interaction with the IEEE Spanning Tree protocol.
Correct Answer: B
QUESTION 12
What does the EIGRP Feasibility Condition mean?
A. The FD must be unique.
B. The FD must be higher than zero.

Read More

Cisco 350-001 Q&A, 100% Success Rate Cisco 350-001 Question Description With 100% Pass Rate

Where to free download the new Cisco 350-001 exam questions to pass the exam easily? Now,Flydumps has publised the new version of Cisco 350-001 exam dumps with new added exam questions.you can also get free VCE and PDF, and the new Cisco 350-001 practice tests ensure your exam 100% pass. Visit Flydumps.com to get the 100% pass ensure!

QUESTION 35
The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does this mean?
A. The PVC is configured correctly and is operating normally, but no data packets have been detected for more than five minutes.
B. The PVC is configured correctly, is operating normally, and is no longer actively seeking the address of the remote router.
C. The PVC is configured correctly, is operating normally, and is waiting for interesting traffic to trigger a call to the remote router.

Read More

Cisco 350-001 Cert, The Best Cisco 350-001 Demo Free Download On Sale

[The Newest Dumps] Real Cisco 350-001 exam dumps revised by experts, they were updated with the change of the Cisco 350-001,covering all the whole aspects of Cisco 350-001 exam. Just have a training of Flydumps Cisco 350-001 exam questions to guarantee your 100% pass

QUESTION 11
Spanning Tree Protocol calculates path cost based on which of these?
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
Correct Answer: A QUESTION 12

Refer to the exhibit. What problem does the debug ip ospf event output from R3 indicate?

A. 209.165.202.140 and R3 are not both configured as OSPF stubs.

Read More

Cisco 350-001 Preparation Materials, Sale Discount Cisco 350-001 Certification Exam Are Based On The Real Exam

Good News´╝üwho Want to get Cisco 350-001 Certified? We know that the Cisco 350-001 certification exam is challenging, but with the new version Cisco 350-001 exam dumps, you will pass the exam easily and quickly.Free download the VCE and PDF files on Flydumps.com

QUESTION 39
Customer X has a hub-and-spoke Frame Relay network, with a central office and two branch offices (RemoteA and RemoteB). Each location has only one physical link to the Frame Relay cloud and RemoteB has a router that is not a Cisco router. Since the installation,there is no connectivity between RemoteB and the central office. What is a possible solution to this issue?
A. Because Frame Relay IETF encapsulation is only configurable at interface level, you must use IETF encapsulation on all routers.
B. This is not a possible scenario. A dedicated Frame Relay link to RemoteB ismandatory at the central office.

Read More

Updated New Cisco 350-001 New Dumps Download with Latest Exam Test Flydumps

Why has this switch not been elected the root bridge for VLAN1?
A. It has more than one interface that is connected to the root network segment.
B. It is running RSTP while the elected root bridge is running 802.1d spanning tree.
C. It has a higher MAC address than the elected root bridge.
D. It has a higher bridge ID than the elected root bridge.

Correct Answer: D Section: (none)Explanation
Explanation/Reference:
QUESTION 2
Refer to the exhibit . Which switch provides the spanning-tree designated port role for the network segment that services the printers?

A. Switch1
B. Switch2
C. Switch3
D. Switch4

Correct Answer: C Section: (none)Explanation
Explanation/Reference:
QUESTION 3
Refer to the exhibit.

Read More

FLYDUMPS – Take Your Cisco 350-001 All New Questions And Answers Flydumps Download

Exam A
QUESTION 1
Which of these statements about penultimate hop popping are true? (Choose three)
A. It is used only for directly connected subnets or aggregate routes
B. It can only be used with LDP.
C. It is only used when two or more labels are stacked.
D. It enables the Edge LSR to request a label pop operation from Its upstream neighbors
E. It is requested through TDP using a special label value that is also called the implicit-null value.
F. It is requested through LDP using a special label value that is also called the implicit-null value.

Correct Answer: ADF
QUESTION 2
Refer to the exhibit. R4 is a remote office router that is running EIGRP; the decision has been made to change EIGRP to use static EIGRP adjacencies. However, once the configuration change was applied, the adjacency between R4 and 209.165.202.139 (HQ) seems to disappear. What could be the cause of this issue?

Read More

Cisco 350-001 Exam Certification – 100% Free VCE Files Flydumps

Exam A
QUESTION 1
What is the effect of using the “logging ari_server” command?
A. logs messages to the console named ari_server
B. logs messages to a syslog server named ari_server
C. logs messages to the buffer of the ari_server console
D. logs messages to a virtual terminal line called ari_server

Correct Answer: B
QUESTION 2
Which of the following provide for IBM mainframe attachment?
A. FIP
B. TRIP
C. CIP
D. FEIP

Correct Answer: C
QUESTION 3
If the DTE side of a serial link is in the condition below, which of the following actionsmay be taken to determine the problem?

Read More

Valid Cisco 350-001 Download IT Exam Study Guide Flydumps To Pass Exam Easily PDF And Vice

Exam A
QUESTION 1
What does the following IOS configuration on the Catalyst 2950 accomplish? Switch(config)# wrr-queue bandwidth 10 20 70 1 Switch(config)# no wrr-queue cos-map Switch(config)# wrr-queue cos-map 1 0 1 Switch(config)# wrr-queue cos-map 2 2 4 Switch(config)# wrr-queue cos-map 3 3 6 7 Switch(config)# wrr-queue cos-map 4 5
A. It enables frames with a CoS 0 or CoS 1 marking to be serviced by WRR (Weight Round Robin) queuing with a weighting value of 1.
B. It enables frames with a CoS 5 marking to be serviced by the expedite queue.
C. It guarantees 10% of the link bandwidth to Queue 1 and 20% to queue 2 and 70% to queue 3. Queue 4 is not used.
D. It sets up the CoS-to-DSCP mappings and DSCP-to-CoS mappings.
E. It sets up the WRR queuing where frames with a CoS of 3 or 6 or 7 will have the highest priority.
Correct Answer: B
QUESTION 2
What VLAN trunk protocol has these characteristics?

Read More

100% Valid Download From Flydumps Latest Cisco 350-001 Pdf Exam Free Practice Test Ensure You 100% Pass From Flydumps

Exam A QUESTION 1
Given the shown output, which statement is true regarding the router forwarding a packet to 192.168.32.1?

A. The packet will be forwarded to 10.1.1.1.
B. The packet will be forwarded to 10.1.1.2.
C. The packet will be forwarded to 10.1.1.3.
D. The packet will be forwarded to the default gateway.
E. None of the above — this is an invalid output.

Correct Answer: A
QUESTION 2
In the illustrated network, all routers are configured to run EIGRP on all links. R2 is configured to send a summary route only to R4, R5, and R6. If the link between R1 and R2 fails, what is the maximum number of queries R3 will receive for 192.168.1.0/24, given that all the packets transmitted during convergence are transmitted once (there are no dropped or retransmitted packets)? Will R4, R5, or R6 receive any queries?

A. R3 will receive one query for 192.168.1.0/24, from R2. R4, R5, and R6 will each receive, and reply to, one query each.
B. R3 will receive 4 queriesfor 192.168.1.0/24, one each from R2, R4, R5, and R6. R4, R5, and R6 will each receive, and reply to, one query each.

Read More

Cisco 350-001 test: High Pass RateCisco 350-001 Flydumps With All New Exam Questions

QUESTION 1
You have a Catalyst 6500 with a Supervisor IA with a MSFC. After a power outage, the MSFC has lost its boot image and now will only boot into ROMMON mode. You want to load a new image onto the Catalyst MSFC boot flash. What method can you use?
A. Console connection using Xmodem
B. FTP
C. TFTP
D. SNMP
E. SSH
Correct Answer: A
QUESTION 2
Which of the following statements regarding the use of SPAN on a Catalyst 6500 are true?
A. With SPAN an entire VLAN can be configured to be the source.
B. If the source port is configured as a trunk port, the traffic on the destination port will also be tagged, irrespective of the configuration on the destination port.
C. In any active SPAN session, the destination port will not participate in Spanning Tree.

Read More