350-025 - Unlimited Lifetime Access to 1800+ Certification Exams Questions & Answers

Cisco 350-025 Free Demo, The Most Effective Cisco 350-025 Exam On Sale

cisco300June 28, 20160

important Info: These new valid Cisco 350-025 exam questions were updated in recent days by Cisco 350-025,please visit our website to get the full version of new Cisco 350-025 exam dumps with free version of new VCE Player, you can pass the exam easily by training it!

QUESTION 66
What is the correct sequence of events when an asynchronous PPP client dials into a router with the configuration shown above? (assume the router and modem configurations are set properly)

A. The modems sync up, DTR goes high, and the router starts PPP.
B. The modems sync up, CD goes high, and the router starts PPP.
C. The modems sync up, DSR/CD goes high, and the router starts PPP.
D. The modems sync up, DSR/CD goes high, the router prompts for a username, but instead the PPP activation character is seen by the router. The router aborts the login prompt and PPP is started on the router.

Cisco

Reliable Cisco 350-025 Certification To Pass Exam Easily Guarantee You 100% Pass Download

cisco300May 4, 20160

Exam A
QUESTION 1
What command is used to set the length of time a non-ISDN interface stays down after a call has been completed or has failed and before it is available to dial again?
A. dialer enable-timeout
B. dialer holddown
C. dialer fast-idle
D. dialer idle-timeout
E. dialer wait-for-carrier-time
Correct Answer: A
QUESTION 2
interface Dialer1 ip address 1.1.1.1 255.255.255.0 encapsulation ppp dialer remote-name Smalluserdialer string 4540 dialer pool 3 dialer-group 1 What statement about this configuration is true?
A. This interface is configured for legacy DDR and therefore cannot be used for dialer profiles.
B. This interface is a logical interface whose configuration is only used for inbound calls on physical interfaces in pool 3.
C. This logical interface belongs to a group of physical interfaces in group 1.
D. This configuration is not valid because it is missing the “dialer in-band” command.